Home > Inline Skates > Speed Skates >

Vanilla Carbon Speed Skates Green

Vanilla Carbon Speed Skates Green
click on additional photos

sz 1-5 - 3 wheel version

Product price is not filled in. This product cannot be purchased.

List Price: $279.99
You'll earn 249 points

Availability: SOLD OUT
Product Code: VN-CBG


Description Sizing Info
Vanilla Carbon Speed Skates Green MEN'S SIZES Performance racing skates package for serious racing action. Carbon fiber racing skates for indoor roller skate racing.

-1/2 Fiberglass 1/2 Carbon Fiber boot

-7000 Series Aluminum Frame

-Sizes 1 through 5 come with a 3x100 frame

-Sizes 6 through 13 come with a 4x100 frame

-85A indoor/outdoor wheel

-ABEC9 Vanilla Racing Spec bearing

Vanilla Skate shoes Heat Molding Instructions

1. Remove wheels and bearings. Leave the frames attached to the boot. The frame should be snug on the boot, but not overly tight. You should be able to move the frame from side to side when you apply pressure with your hands.

2. Turn on oven and set temperature to 175 – 200 degrees Fahrenheit. Do not go beyond 200 degrees at any time for any reason.
3. Heat and mold one boot at a time. Before putting your boot and frame in the oven, be sure to loosen the laces enough to easily slide your foot in the boot.
4. Place the boot and frame in the oven. Make sure not to let the boot or frame make contact with the heating elements.
5. Check the oven after 10 minutes to see if the boot is pliable. If you’re not satisfied with the pliability, check it every minute with a maximum of 10 additional minutes.
6. Remove from oven with caution! Use hot pad or mitt to remove the boot and avoid contact with the frame and eyelets.
7. While sitting in a chair, place the boot on your foot and lace your boots snug – do not over‐tighten. Be sure to wear a sock during this process to protect your foot against the heat. Do not stand on the frame until your boot has completely cooled.
8. While sitting, keep your hip and knee in line. Your knee should be directly over your toes. This is an important position to maintain during the molding process.
9. Once your boot has completely cooled, repeat steps 1‐8 for the other boot/frame.

Additional Molding Tips

a. Most skaters have made great use of a handled screw driver to push out the ankle bone while your boot is hot and pliable. Using the handle to apply pressure can help move the shell out to specific points.
b. If you find that the toe box is tight, use your thumbs to press and hold out the areas in the toe box of your boot while the boot is hot and pliable.
c. To tighten the heel cup and tendon, place your hands around the back of the boot and squeeze the boot together.

Hold the cup/tendon tight until the boot has cooled.

Accessories for this product...
R-Fit Footbed Kits For Mens Skates
Our Price: $49.99

R-Fit Footbed Kits For Mens Skates

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Inline Skates > Speed Skates
Inline Racing Skates
Inline Skates
Inline Skates > Vanilla Speed Skates