K2 Recon MSL, Pro Longmount, and Ice Svenbock speed skating boots are fully heat moldable and provide the fit of a custom boot at a fraction of the custom price. The boot is designed and pre-molded to fit an average size ankle out of the box. But this area may not match your particular ankle shape well prior to heat molding. It is important to mold the boot properly before use to obtain optimum fit and performance.
Note: If you have access to a vacuum pump through your local skate shop professional or race club coach then use the vacuum pump and bagging method to replace step 4C listed below. The vacuum bagging method will give the best fit possible.
Please follow the instructions below:
1. Supplies:A. Conventional oven or convection oven (Do not use a microwave oven. It will damage the boots).B. Thin socksC. An assistant to help make things easier.D. 1 or 2 elastic bandages
2. Boot Preparation: A. If attached, remove the frame and mounting screws from the bottom of the boot.B. Lace the boots loosely and close the lace cover.
3. Heating the Boots:A. Turn the oven on and set it to 225F (110C).B. When the oven reaches 225F (110C), turn the oven off.C. It is recommended that you heat and mold the boots one at a time. D. Place a boot (without frame and mounting screws) in the center of the oven, equally spaced on all sides from the heating elements and set the timer for 10 minutes. E. After 10 minutes the sides of the boot and ankle area should become noticeably flexible. The boot is now ready to be custom fit. Ovens may vary so please use the above time as a guideline only. If the boots are not flexible after 10 minutes then leave them in the oven for an extra 5 minutes. DO NOT increase the temperature setting. Boots that have been damaged by excessive heating from any means (heat gun, oven, etc.) are not covered under warranty.
4. Molding the Boots:A. Put on a thin sock on the foot to be molded. Take the boots out of the oven and put them on immediately. Warning - the metal eyelets will be HOT to the touch! Please be careful.B. Lace the boots until they are snug, but not as tight as one might skate in them because the leather around the eyelets can be damaged when it is warm and soft.C. Wrap each boot tightly with the elastic bandage, just as one would bandage an ankle. Fix the bandage in place to keep it from unravelFeatures
Materials: Hand Stitched Leather, Suede Liner, Carbon Torsion Spar Outsole Closure: Lace, Lace Cover, Ratcheting Buckle Sizing: Men's 6.0 - 13.0 (full and half sizes) EU 35-46
Copyright © 2012 Skates.com. All Rights Reserved.
Built with Volusion