Slighly smaller than the regular "Gripper", These are also 5/8 inch adjustable stoppers designed for speed skating. Adjustable means you can wind the stopper up closer to the boot or down farther from the boot, making the stopper lower to the ground or higher up from the ground. Stopper measure 1-1/2" (38mm) at its widest point, 1-9/16"(42mm) FRONT TO BACK,3/4"(20mm) at the thickest point on front and 3/8" (10mm) at the thinnest point on back. Shaft is 5/8" diameter and 1" (26mm) in length


Features

- Sold in pairs
- adjustable-lengthen or shorten the distance from the stopper to the ground
- Fits most plates that require adjustable stops (i.e. century, atlas, probe, invader).
- Shaft is 5/8" diameter and 1" (26mm) in length
- Stoppers measure 1-1/2" (38mm) at the widest point, 1-9/16"(42mm) FRONT TO BACK, 3/4"(20mm) at the thickest point on front and 3/8" (10mm) at the thinnest point on back. Shaft is 5/8" diameter and 1" (26mm) in length.

• Name - AD
  hello can you tell me which stoppers i should use for the european threaded powerdynes that I use for outside. the old owner had toe plugs and didnt hit the streets like I do...?
  

Tech Specs